Forums
Forum Tools
|
 |
02:56:39 - 12/29/2024
Dakota Performance
| From | Message |
MikeD
*R/T*
7/26/2002
13:48:50
|
 Subject: New Pushrods?
IP: Logged
Message:
I'm about to install 2.02 heads and 1.6 Comp Cams RR's. I have a .512/.512 lift cam in it already, will my stock pushrods be too long or too short or will the RR's bolt right up w/o any trouble?
~Mike~
Get In...Sit Down...Shutup...& Hangon
|
5pnt9ltrluv
R/T
7/26/2002
14:25:01
|  RE: New Pushrods?
IP: Logged
Message:
If i am not mistaken, I think the stock ones might be ok. I think the 1.6's are not that deviate from the original rockers...But I am not an expert, I just play one on TV...
Kris
Powerdyne w/ 6#, True dual Flowmaster 40's, MSD 6BTM w/ Blaster SS coil, Taylor 8mm, Flowmetrics 50mm t- body, JBA headers, Autolite 3923's, 180 degree T-stat, , Ported 1.92 R/T heads, 4bbl M1, 24# injectors, Crower 1.7 Roller Rockers, Hotchkis 2/3 w/ Nitro shocks, GTS hood
|
MikeD
*R/T*
7/26/2002
14:36:57
| RE: New Pushrods?
IP: Logged
Message:
HAHA...well I guess the only way to find out is take one off and try it and if it fits go w/ it.
~Mike~
Get In...Sit Down...Shutup...& Hangon
|
rtdkota
Dodge Dakota
JOIN HERE
7/27/2002
01:20:40
| RE: New Pushrods?
IP: Logged
Message:
If that's a new cam, non regrind-- it should be okay with the 6.900" stockers.. Otherwise, if you rev the crap out of it.. step up to a 6.950"
Double check the stockers.. they should be 6.900"
(I sell Crower roller rockers and cams... And with my setup, 6.950" on my stock cam, and 7.000" on my custom regrind Crower cam due to smaller base circle).
Sam
www.socaldakota.com
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
