| From | Message |
Aaron Weather
Dodge Dakota
JOIN HERE
5/23/2002
13:25:55
|
 Subject: rear end gears
IP: Logged
Message:
Has anyone done gears? Are they hard to do? What ratio is best? I have a 2000 R/T, and solved my traction problem with MT ET Streets but now the tires are larger in circumference and my ETs have dropped. Any help would be appreciated!
|
Knobbyman
*GenIII*
5/23/2002
15:02:37
|  RE: rear end gears
IP: Logged
Message:
If your doing 1/4 mile I think 4.10 is about standard.
'01 Graphite QC 4x4
4.7 3.55 LSD
4.5" Customized Suspension Lift
305x70x16 GoodYear MT/R's
http://www.knobbyman.com
----Speed only breaks stuff faster----
|
hardbody
Dodge Dakota
JOIN HERE
5/23/2002
16:39:30
| RE: rear end gears
IP: Logged
Message:
Just remember when you replace your tires with slicks to race make sure the tires are the same size or smaller than the tires you run on the street, otherwise you will actually make the truck slower.
|
RTjohn
Dodge Dakota
JOIN HERE
5/23/2002
19:25:00
| RE: rear end gears
IP: Logged
Message:
The stock 3.92 gears are more than enough for the 1/4, you will not notice big improvement with a 4.10!
RTjohn
|
Aaron Weather
Dodge Dakota
JOIN HERE
5/24/2002
00:33:24
| RE: rear end gears
IP: Logged
Message:
The 3.92's are a good gear but with the tires I am not hitting third gear in the 1/4. I was planning to go with 4.56's since I don't drive it regularly and I have the luxury of overdrive. Is that overkill?
|
kota on 20s
GenIII
5/24/2002
00:54:17
| RE: rear end gears
IP: Logged
Message:
there are a couple of guys on the delphi board that have 4.56's and LOVE them!! if you dont drive much highway, they are the way to go!
Eric, 98 5.2 5speed, K&N gen II, 50mm TB, 2bbl M-1, 1.7RR's, JBA ciramic headers, carsound cat, dumped gibson, and a lot more
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
