| From | Message |
Tim
Dodge Dakota
JOIN HERE
3/12/2002
13:45:39
|
 Subject: Traction bars
IP: Logged
Message:
Has anyone had any experience with the slide-a-link traction bars from competition engineering. I am looking to install a pair and would like to know if anyone has used them.
98 dakota cc,5.2ltr,5speed. headers, 3 inch exhaust, bored tb, msd, 3.55 posi rear,
|
DaveR
Dodge Dakota
JOIN HERE
3/12/2002
17:35:18
|  RE: Traction bars
IP: Logged
Message:
I have about 9 months experience with them. I like them; they are adjustable and have a differenct look to them. They are, however, a pain to put on. I talked tom someone on here about 2 weeks ago about them and I took pics of them if you care to see.
|
Tim
Dodge Dakota
JOIN HERE
3/13/2002
20:30:13
| RE: Traction bars
IP: Logged
Message:
Thanks Dave, I have acsess to a lift and press which should make it easier. Do you keep them set tight on the road? Yes I would like to see the pics.
|
DaveR
Dodge Dakota
JOIN HERE
3/13/2002
22:10:13
| RE: Traction bars
IP: Logged
Message:
Now I keep them at the recomended on road setup. This is .25" gap between the bushing and the stop on the passenger side and .25" and an extra turn for the drivers side to compensate for weight. It can be a fairly rough ride if they are snugged down for race setup. I think if I was going to do it over again I would get different bushings made out of Delrin or PEEK so it wouldn't squeek, but you get used to it. what's you address?
|
Tim
Dodge Dakota
JOIN HERE
3/16/2002
10:02:40
| RE: Traction bars
IP: Logged
Message:
Dave my e mail is twedin@tampabay.rr.com
|
DaveR
Dodge Dakota
JOIN HERE
3/17/2002
17:24:56
| RE: Traction bars
IP: Logged
Message:
You've got mail.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
