Forums
Forum Tools
|
 |
02:37:02 - 12/29/2024
Dakota Performance
| From | Message |
Jim
Dodge Dakota
JOIN HERE
2/20/2002
19:30:16
|
 Subject: V8 TB prep for V6 install
IP: Logged
Message:
I just acquired a V8 TB from a 5.2L motor.
I will be installing it on a 2000 3.9L w/5 speed, Intense cold air intake, series 50 full flow muffler, relocated IAT and Jet chip.
I have access to a milling machine and I know how to use it! So what should I do to prep the TB? I am aiming for low and mid range power for pulling.
Thanx
Jim
|
DakotaDan
GenIII
2/20/2002
21:03:55
|  RE: V8 TB prep for V6 install
IP: Logged
Message:
Jim
I just got my V8 TB today, First I thought I would wait till the weekend and put it on, then the more I looked at it I thought naaaa...... Do It !
Got mine from the Dealer it had the cable bracket and all the sensor's but the MAF already on it.
First off it is a breeze I had the TB off, the new one on and the TB cable changed in just a little over an hour, reset the PCM and fired it up, let it idle for a min. or 2, shut it off, Fired it up again and out the drive I went for a 30 mile test. For now I feel like I may have lost a little low end around 40-45 mph will just have to see how the PCM sets things up over the next few days. Other than that it is a great addition to my truck, When you stomp down on it goes.........
Personally I wouldn't try to modify the V8 TB, it's plenty big enough for a mildly modified V6, the fact that you have a 5spd should be to your advantage for any low end loss.
Good luck
Dan 
01 CC SLT V6 Auto
K&N FIPK # 57-1517
DynoMax # 17748
Factory Flares
WeatherFlectors
Low Profile Tonneau
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
