| From | Message |
Dakaty
Dodge Dakota
11/25/2001
17:14:46
|
 Subject: IAT & Jet Chip & 5.9L
IP: Logged
Message:
At the risk of getting chewed out for bringing up an old subject and asking a redundant question...
I just received by SpeedTweaks IAT adjuster. I currently am running a Jet 1 chip on my 5.9L auto 2001 QC. Should I remove the Jet Chip when I install the IAT?
I did review some older posts that pertained to the 4.7 engine. Those posts suggested that the IAT and the Chip did not work together.
I was wondering if anyone had experience with the 5.9 and how it responded??
Thanks
Bill
|
CW
GenIII
 
11/25/2001
17:48:59
|  RE: IAT & Jet Chip & 5.9L
IP: Logged
Message:
No they do not work together all the jet chip does is adjust the IAT signal. If you run both it will throw the IAT adjuster calibration way out. The adjuster is better than the jet 1 because you can tune it to your specific truck and combo. BTW I have seen dyno charts where the jet 1 took away 9hp on the 5.9 at full throttle but at part throttle gave 10hp. Not what I would want personaly, better at part throttle but worse at WOT.
2001 4.7 5sp RC 3.91 sport plus
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
