| From | Message |
jacksdodges
GenI
11/09/2009
21:47:53
|
 Subject: shelby dakota transmission
IP: Logged
Message:
I'm wanting to put a carb. on my Shelby Dakota. My question is will the transmission and overdrive still work when I go to a carb and MSD ignition.Since the computer wont be wired to the distributor anymore.
jack mcknight
|
daddio
Dodge Dakota
JOIN HERE
11/16/2009
10:22:06
| RE: shelby dakota transmission
IP: Logged
Message:
I'm not 100% sure but, I think you probably have an RH series trans which is not electronically controlled so those mods would not affect it. Maybe someone a little more familiar will chime in.
|
Mike S.
Dodge Dakota
JOIN HERE
11/18/2009
20:50:12
| RE: shelby dakota transmission
IP: Logged
Message:
You should have the A500. The trans will work and function fine other than OD and converter lock-up. There is a 3 prong plug on the side of the trans that is the wiring for lock-up and OD. The center wire is a ground and the outter wires need a 12v source. I wired up my 91 so that lock-up and OD came in at the same time via the factory dash switch. My trans functions like a 904 nonlock-up around town but when I get on the highway I can push the button and have OD and lock-up. Hope this helps, Mike
|
jacksdodges
GenI
11/20/2009
07:35:49
| RE: shelby dakota transmission
IP: Logged
Message:
Thanks Mike this is what ive been wanting to hear. I guess you have to remember to push the button when you slow back down. Thanks
jack mcknight
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
