| From | Message |
FtMyersR/T
Dodge Dakota
JOIN HERE
2/18/2005
16:07:54
|
 Subject: MSD problem on 5.9
IP: Logged
Message:
So I installed my new cap, rotor, Taylor 8mm wires and MSD 6A box the other day and everything was running fine until yesterday after work. The truck wouldn't start after work. I checked all of my connections between the stock coil wires and the MSD wires and everything seemed fine. I went ahead and took the connectors off and actually twisted the wires together so I knew they were connected. Still it wouldn't start. I un-hooked the MSD and connecte the wires back to stock and it worked. Everything else for the MSD (positive and negative connections) were solid. Any ideas?
|
prple-gaseatr
Dodge Dakota
JOIN HERE
2/18/2005
16:11:40
| RE: MSD problem on 5.9
IP: Logged
Message:
your ignition box might have took a sh!t. ive heard of it before, is the box new or used?
|
FtMyersR/T
Dodge Dakota
JOIN HERE
2/18/2005
16:14:10
| RE: MSD problem on 5.9
IP: Logged
Message:
Box is brand new. Ordered it from KRC Performance like 2 weeks ago.
|
prple-gaseatr
Dodge Dakota
JOIN HERE
2/19/2005
16:55:06
| RE: MSD problem on 5.9
IP: Logged
Message:
i would check if its putting out any power anyway just to be sure
|
Chris
Dodge Dakota
JOIN HERE
2/20/2005
02:58:54
| RE: MSD problem on 5.9
IP: Logged
Message:
I had the same problem with my 3.9. First check the battery and connections. Then check the ground wires. Mine problem was the ground wire and the coil. I just sand the ground wire and the coil. It works now. Hope this works.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
