| From | Message |
David
Dodge Dakota
JOIN HERE
5/05/2003
23:34:27
|
 Subject: how to replace '95 Dak clearance bulbs?
IP: Logged
Message:
My '95 has a front clearance bulb out and I do not see how to replace it. I can see the headlight and turn signal bulbs from behind the lights. How do I replace the small bulb that goes in the front corner clearance light?
Also my backup lights do not work - any insights on this? The bulbs are good.
Thanks
|
DAHEMIKOTA
Dodge Dakota
JOIN HERE
5/06/2003
01:35:13
|  RE: how to replace '95 Dak clearance bulbs?
IP: Logged
Message:
You got to remove the bezel to get at the bulb. It should be in a holder pushed into the housing. The bulb is the type that pushes into the holder.The fuse for the backup lamps is # 2. (10 amp) You may also check the switch on the transmission. Make sure there is no corrsion on the pins.The same fuse also goes to the A/C cycling switch. Hope this helps. Dan
|
david
Dodge Dakota
JOIN HERE
5/07/2003
09:49:29
|  RE: how to replace '95 Dak clearance bulbs?
IP: Logged
Message:
How do I remove the bezel? I'm not sure what you mean - the colored trim section that covers the actual light? Please help me understand....
thanks
|
john
GenII
5/07/2003
20:54:39
| RE: how to replace '95 Dak clearance bulbs?
IP: Logged
Message:
The bezel is the piece that goes around the headlight. 4 screws hold it in 2 on top 2 on the bottom.
92 CC 4x4 318
|
david
Dodge Dakota
JOIN HERE
5/07/2003
23:07:14
|  RE: how to replace '95 Dak clearance bulbs?
IP: Logged
Message:
Thanks John - I found the two on top but could not get the two on the bottom out - was ok though, I had enough clearance to change the bulb.
thanks to all for the help.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
