|
|
|
|
||
|
||
| From | Message |
| arribc Unregistered  1/03/2001 15:13:48 |
 Subject: Resetting the ECUIP: Logged Message: How do you reset the ECU on a 3.9 Dakota? Thanks |
| Bernd GenIII  1/03/2001 15:49:01 | RE: Resetting the ECU IP: Logged Message: To reset the computer is easy: (1) Disconnect the NEG terminal on the Battery (2) Turn the key to the START position and hold fro 15 seconds (3) Turn key OFF and reconnect the battery This bleeds any residual energy in the system and reset the PCM. Bernd D. Ratsch 1997 Dodge Dakota SLT Supercharged w/Nitrous |
| Tom Unregistered 1/04/2001 08:52:55 | RE: Resetting the ECU IP: Logged Message: In my CRX I just yank the ECU fuse out for a couple minutes and then put it back in. And when you start up the car it sets then. But I have to make sure not to pump the gas or anything or it would screw all that up. Tom (Someday I'll have my truck....someday) |
| Rerun Dodge Dakota JOIN HERE 1/17/2005 00:01:12 |  RE: Resetting the ECUIP: Logged Message: Oh, man! This one goes way back. |
| Daniel Dodge Dakota JOIN HERE  1/20/2005 20:10:19 | Trouble starting IP: Logged Message: My Father has a 95 Dodge Dakota and it won't start all of the obvious has been checked. It wont even click or try to turn over. The Battery is at full charge. However the battery was disconnected at one point and and reconnected and it is now giving us the diagnostic code of 12, which indicates that the battery has been disconnected. How do I get the original diagnostic code before the disconnection. Please someone give me some advice my Dad's taking the Bus at 5am every morning. |
| JasonB Dodge Dakota JOIN HERE 1/20/2005 20:45:41 | RE: Resetting the ECU IP: Logged Message: You can not retrieve PCM fault codes after a battery disconnect. |
| P 1 | |
Post a reply to this message: Username Registration: Optional All visitors are allowed to post messages |
|
Home | Photos | Message Board | Links | Classified | Mailing List | Contests | Feedback |
 |
Property of Virtual-Masters, Inc. |
 |